DentGist NanoCom Restorative Composite Refills 4g

Composition:

Bisphenol A Glycidyl Methacrylate.
Bisphenol A Diethoxy Methacrylate.
Urethane Dimethacrylate.
Triethylene Glycol Dimethacrylate.
Silanated Barium Glass Powder.
Amorphous Fumed Silica.
Store at a temperature between 10°C to 24°C. Close the cap carefully after use. Keep away from moisture.

Isolation : Rubber dam is the preferred method of isolation
Cavity preparation : Prepare cavity with minimal tooth reduction. Bevel cavo surface enamel margins.
Apply Etchant Gel to enamel and dentin surfaces for 15 seconds. Rinse thoroughly for 15 seconds with water
Dry with clean, oil-free, air without desiccating the dentin
Do not allow etched surface to become contaminated with saliva or blood during the bonding procedure
Adhesive : Immediately after blotting, apply 2-3 consecutive coats of adhesive to etched enamel and dentin for 15 seconds with gentle agitation using a fully saturated applicator. Remove excess solvent by gently drying with dry air for at least 5 sec to ensure uniform glossy surface. Light cure for 20-30 seconds
Composite placement : Remove composite syringe cap and dispense material onto a mixing pad
Place the material into the cavity using a suitable placement instrument.
After dispensing, screw plunger should be rotated anticlockwise by half to full turn to release residual pressure inside the syringe
Contour the material in the cavity.
Light cure for 40 sec using standard curing light.
When necessary build in increments of 2mm maximum using a layering technique.
Shape and polish with a Polishing system using standard technique.

July 2026